Nortel WLAN Security Switch 2361 Przewodnik Instalacji Pobierz pdf (Strona 10)

10 Basics of Avaya WLAN Series 2332 Outdoor Solution

NN47250-506 (324883-B Version 02.02)

RF radiation exposure and hazard statement

To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such

that the antenna of the device will be greater than 20 cm (8 in.) away from all persons. Using higher gain

antennas and types of antennas not covered under the FCC certification of this product is not allowed.

Installers of the radio and end users of the product must adhere to the installation instructions provided in this

manual. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Non-modification statement

Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unauthorized

antennas, modifications, or attachments could damage the WLAN 2332-A1 and related Series 2332 Access

Points and violate FCC regulations. Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment. Contact Avaya for a list

of approved 2.4 GHz and 5.0 GHz external antennas.

This device must be operated with the CAT-5 Ethernet cable installed on each activated Ethernet Port of a

Series 2332 Access Point to ensure compliance with the Class B emissions standards. Failure to comply with

this installation requirement may cause the device to operate in excess of the allowable emissions limits.

Deployment statement

This product is certified for indoor deployment only. Outdoor operation is allowed by exception only.

Please follow the guidelines outlined in the Outdoor Operation Section in this guide.

Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands

The 2332-A1 access point has been prohibited, via software, from operating in the 5250 to 5350 MHz and

5470 to 5725 MHz frequency bands for the US and Canada because it cannot meet the DFS requirements as

outlined in the rules of the FCC for Part 15, Subpart E that went into force on July 20, 2007.

Canadian IC statement

IC: 332R-2332 (Applies to 2332-A1).

Operation is subject to the following two conditions in Canada:

1 this device may not cause interference, and

2 this device must accept any interference, including interference that may cause undesired operation of the

device

To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this device is

intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its

transmit antenna) that is installed outdoors is subject to licensing and not supported by the WLAN 2332-A1

Access Point.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 119 120

Brak uwag

Nortel WLAN Security Switch 2361 Przewodnik Instalacji Strona 10